SKU: PITSCR
MPN: SCR
These 1 inch self tapping screws from PIT-PAL PRODUCTS are steel fasteners built for mounting panels, brackets, and shop fixtures without a separate tapping operation. The hex head takes a nut driver or socket, which speeds up repetitive installs and gives you more torque than a slotted or Phillips drive. Each screw runs a 7/32 in thread diameter at a 1 in length, sold as a single piece so you buy exactly what a job calls for. They suit garage builds, trailer interiors, and pit equipment where a fast, reliable thread into sheet metal or thin stock matters. Browse the rest of our fasteners selection for matching hardware.
The 7/32 in thread cuts its own mating threads as it drives, which works well in sheet metal, thin steel, and similar materials where pre-drilling slows you down. The steel body carries a zinc oxide coating for corrosion resistance, so these hold up in shop and semi-exposed environments better than bare steel. The hex head profile is the main driver advantage here: it seats square in a socket or nut driver and resists cam-out under load, letting you run them tight without stripping the head. At 1 in long, they bite deep enough for solid panel anchoring while staying short enough for thin-wall applications. Pair them with a flat washer when you need to spread clamping load across softer panel material.
Reach for these when you are securing aluminum or steel panels, fastening interior trim in a race car or trailer, or mounting brackets to a wall or workbench. The self tapping design means one tool and one pass for most installs, and the zinc oxide finish keeps them serviceable in a working shop. Buy them individually to top off a hardware drawer or stock spares for the trailer. For larger panel and trim projects, check our locknuts and the broader bulk fasteners category to round out a build.
These PIT-PAL PRODUCTS screws use a 7/32 in thread diameter and measure 1 in long. The self tapping thread cuts its own mating threads as it drives, so you can install in sheet metal and thin stock without a separate tapping step.
No. The self tapping design forms its own threads as it drives into sheet metal, thin steel, and similar materials. A pilot hole can help with harder or thicker stock, but for typical panel and bracket work these are made to go in without one.
They have a hex head, so they take a nut driver or a socket. The hex profile seats square and resists cam-out, which lets you apply more torque without stripping the head compared with a Phillips or slotted screw.
Yes. The steel body carries a zinc oxide coating that adds corrosion resistance over bare steel, making them suitable for shop, trailer, and semi-exposed mounting applications. For fully marine or constantly wet environments, stainless hardware would hold up longer.
Each screw is sold individually, so you buy exactly the count your job calls for. That makes them handy for topping off a hardware drawer or keeping a few spares in the trailer for panel and bracket repairs.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
