Out of stock
SKU: TIP8142-50
MPN: TIP8142-50
The Ti22 Performance Body Saver Plates 50pk (TIP8142-50) are stainless steel reinforcing plates built for sprint car body panels and the quick-turn fastener hardware that holds them on. Each plate measures 2 inches wide by 1 inch tall and backs up a fastener hole so the panel material doesn't tear under vibration, wind load, and repeated removal. Racers running aluminum or composite bodies use these to spread fastener load across a wider footprint. The 50-pack count gives you enough to plate an entire car and keep spares on hand. Browse the full fasteners category for matching quick-turn hardware.
Each plate is stainless steel with a natural, uncoated finish, so it resists corrosion without adding paint or plating that can flake at the rivet point. The 1/8 inch rivet attachment hole accepts standard pop rivets used in sprint car body fab work, letting you fix the plate to the back side of a panel before installing the quick-turn fastener through it. At 2 by 1 inches, the footprint is large enough to carry load away from a single hole but compact enough to tuck behind narrow panel edges and flanges. These are body reinforcing plates, not the fasteners themselves, so they pair with Dzus-style quarter-turn hardware and hood pin systems already on the car. Look at our body fastener kits to round out a panel install.
Reach for these when you're building or repairing a sprint car body and want fastener holes that survive a full season instead of wallowing out after a few nights. They install behind the panel during fab work, or as a field repair when an existing hole has started to crack. The 50-pack is sized for a complete car with extras for the trailer. If you're sorting out quick-turn panel hardware, pair these plates with Dzus plates and check the broader fasteners lineup for rivets, hood pins, and related body hardware.
They reinforce fastener holes in sprint car body panels. The plate mounts behind the panel so quick-turn fasteners pull against stainless steel instead of thin aluminum or composite, which keeps the hole from tearing or wallowing out under vibration and repeated panel removal.
Each plate has a 1/8 inch rivet hole, so you fasten it to the back side of the body panel with a standard pop rivet during fab work. The quick-turn fastener then passes through the plate and panel together, spreading load across the 2 by 1 inch footprint.
Stainless steel with a natural, uncoated finish. Stainless resists corrosion without paint or plating that can chip at the rivet point, which matters on body panels that see weather, dirt, and frequent handling at the track.
The TIP8142-50 comes as a 50-pack, which is enough to plate the fastener locations on a complete sprint car body and keep spares in the trailer for field repairs.
No. These are reinforcing plates only. They pair with Dzus-style quarter-turn fasteners, hood pins, and similar quick-turn body hardware, which you can source separately from our fasteners category.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
