SKU: TRA4882
UPC: 086923048824
MPN: 4882
The Trans-Dapt 4882 is a differential cover gasket cut for the Dana 60 rear axle, the heavy-duty housing found under full-size trucks, vans, and a long list of swapped 4x4 and performance builds. It seals the cover-to-housing mating surface so gear oil stays where it belongs instead of weeping down the back of the differential. If you've ever pulled a Dana 60 cover to service the gears or change fluid, this is the part you reach for on reassembly. TSA stocks it alongside our broader range of gaskets and seals for axle and driveline work.
Trans-Dapt builds the 4882 as a direct-fit replacement, so the bolt pattern and outer profile match the factory Dana 60 cover without trimming or guesswork. The gasket gives you a clean, repeatable seal at the cover face, which matters on an axle that runs hot under load and carries a large oil volume. Using a cut gasket instead of relying on silicone alone keeps the cover at a consistent standoff and makes the next service interval easier, since the surface comes apart clean. It carries MPN 4882, UPC 086923048824, and ships under SKU TRA4882. Pair it with a fresh fill of gear oil and check the pinion side while you're in there, since a leaking Dana 60 pinion seal often shows up at the same time as a seeping cover.
Reach for the 4882 any time you drop the rear cover on a Dana 60, whether you're changing fluid, swapping gears, setting up a locker, or chasing an oil leak. It's a single gasket, sold individually, so order one per axle you're servicing. Clean both mating surfaces down to bare metal, lay the gasket dry or with a light sealant per your preference, and torque the cover bolts evenly. If your build also runs a Ford rear, we carry a matching Ford 9-inch differential gasket and a full lineup of axle and driveline seals.
The 4882 is cut for the Dana 60 rear differential cover, the heavy-duty axle used under many full-size trucks, vans, and 4x4 and performance builds. It's a direct-fit gasket that matches the factory Dana 60 cover bolt pattern and outer profile.
It's sold individually as one differential cover gasket under SKU TRA4882. If you're servicing more than one axle, order one gasket per Dana 60 cover you plan to remove.
The 4882 is a cut gasket designed to seal on its own when both mating surfaces are clean and the cover bolts are torqued evenly. Some builders add a light film of sealant for extra insurance, but it isn't required for a proper seal.
It's worth inspecting. A Dana 60 that's leaking at the cover often shows seepage at the pinion as well. If you spot oil on the pinion side, replacing the pinion seal during the same service saves a second teardown later.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
