SKU: SHRPSBGM16
UPC: 850057873269
MPN: SBGM16
The Sharps Bros. SBGM16 is a machined aluminum grip module built as a direct replacement for the polymer grip module that ships on the Springfield Echelon, in both compact and full-size configurations. It targets Echelon owners who want a steeper grip angle, more aggressive ergonomics, and the heft that comes with a billet frame. Where the factory polymer module weighs about 4 ounces, this one runs roughly 8 ounces, putting more mass low in the hand. For shooters chasing a different feel and a more refined fit on their Echelon, this is the metal swap that does it. Browse our full grip module selection alongside it.
Sharps Bros. machines the SBGM16 from billet 7075-T6 aluminum and finishes it in Mil-Spec black anodize, paired with Brazilian Cherry grip panels for contrast and a warmer feel in the hand. The grip angle sits at approximately 13 degrees, steeper than the OEM Echelon module, with more pronounced curves through the backstrap and front strap. An integrated M1913 Picatinny accessory rail with three slots sits forward of the trigger guard for lights and lasers, and a flared magazine well speeds reloads under pressure. It seats all Springfield OEM Echelon 9mm magazines, so existing magazines carry over without modification. The trade-off for the aluminum build is added weight, which many shooters welcome for recoil control. Compare it against other pistol grip options.
This module fits the shooter who carries or competes with a Springfield Echelon and wants a metal frame that changes the gun's balance and grip geometry. The flared magwell and three-slot Picatinny rail make it a practical choice for a duty or range setup where fast reloads and a mounted light matter. Installation is a direct swap using the Echelon's serialized chassis, so the firearm's legal serialized component stays put. Pair it with a rail-mounted light or a sling solution from our grips, pads and stocks section, and check the Sharps SIG P365 macro grip if you run more than one platform.
Yes. Per Sharps Bros., the SBGM16 is a direct replacement for the Springfield Echelon grip module in both compact and full-size configurations. It uses the Echelon's serialized chassis, so the swap does not change the firearm's serialized component.
The billet 7075-T6 aluminum module weighs approximately 8 ounces, compared to roughly 4 ounces for the OEM polymer grip module from Springfield. That added mass sits low in the grip and helps many shooters manage recoil.
Yes. The SBGM16 seats all Springfield OEM Echelon 9mm magazines, and the module adds a flared magazine well to speed reloads. No magazine modification is required.
The SBGM16 has a grip angle of approximately 13 degrees, which is steeper than the OEM Echelon module. Sharps Bros. also gives it more pronounced ergonomic curves through the front and backstrap for a different hand fill.
Yes. The module includes an integrated M1913 Picatinny accessory rail with three slots forward of the trigger guard, sized for standard lights and lasers that fit 1913 specification rails.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
