Minn Kota Raptor Jack Plate Adapter Bracket - Port - 5" Setback - 4" Rise - Black

The Minn Kota Raptor Jack Plate Adapter Bracket — Port — 5" Setback — 4" Rise — Black is a precision-engineered mounting solution designed specifically for Minn Kota Raptor Shallow Water Anchors. This aluminum bracket attaches directly to your existing jack plate on the port side of your boat, delivering the offset positioning and vertical elevation needed for optimal anchor deployment from your transom while maintaining clean sight lines and deck clearance.

Built from lightweight, single-piece aluminum with a powder-coated black finish, this adapter bracket provides 5 inches of horizontal setback from the transom and 4 inches of vertical rise. The setback distance pushes the Raptor anchor head away from the hull, reducing hydrodynamic interference and improving holding angle in varied bottom conditions. The vertical rise elevates the anchor deployment point, which is critical for boats with high transoms or when fishing shallow flats where anchor flukes need to engage the bottom at the proper angle. The powder-coat finish resists corrosion in freshwater and brackish environments, while the single-piece construction eliminates fastener failures common in welded or multi-component brackets.

This bracket is engineered for shallow water and flats anglers running 18- to 24-foot center consoles, bay boats, and skiffs where precision anchor positioning directly affects your ability to maintain position in wind and current. The port-side configuration balances your boat's weight distribution if you're running starboard-mounted electronics or fish-finder transducers. Minn Kota's Raptor anchor system demands proper geometry for consistent performance—the wrong setback or rise height can result in anchor flukes not engaging correctly or the anchor head catching debris on deployment.

At 11.1 pounds, this adapter is lightweight enough to install without reinforcing your transom, yet rigid enough to handle the lateral loads during anchor deployment at idle speed. Verify your jack plate mounting pattern and ensure your transom thickness supports the stainless hardware before ordering—this bracket is engineered as a direct mount and should be installed by someone familiar with marine wiring and hardware fastening standards.