Lenco Auto Glide Adapter Extension Cable - 20'

The Lenco Auto Glide Adapter Extension Cable – 20' is a marine-grade extension harness designed for boaters and anglers who need to extend their auto-glide trim and tilt control systems beyond standard factory cable lengths. Built by Lenco Marine, a trusted name in marine trim systems for decades, this extension cable allows you to relocate your control pad further from the engine adapter—critical when retrofit installations or custom console layouts require extra reach without signal loss.

This 20-foot extension cable terminates on both ends with ruggedized 4-pin male-to-female Deutsch connectors, the marine industry standard for waterproof, vibration-resistant electrical connections. The dual CAN (Controller Area Network) bus architecture ensures clean, interference-free communication between your control pad and engine adapter, maintaining full system diagnostics and response time. At just 1.25 pounds, the cable resists corrosion and UV degradation, key factors for saltwater and freshwater environments where electrical reliability directly impacts safety and performance on the water.

This extension works with Lenco Auto Glide kits 30246-001, 30252-001, and 30277-001—models common on center console fishing boats, cruisers, and offshore vessels. Installation is straightforward: disconnect your factory adapter cable and splice in the extension to reach custom-mounted control heads, independent monitoring stations, or hardwired remote trim switches on twin or triple-engine setups. Professional installers and DIY boaters alike appreciate the Deutsch connector reliability; there's no soldering or potting compound needed, and connections remain watertight under spray and submersion.