Weld Mount AT-5B Large Black Nylon Wire Tie Mount - Qty. 100

The Weld Mount AT-5B Large Black Nylon Wire Tie Mount bulk pack of 100 units is purpose-built for serious marine applications where reliability and permanence matter. After years on the water, any experienced boater knows that temporary fastening solutions fail when you need them most—exposed to salt spray, UV, and constant vibration. These mounts solve that problem by providing a permanent anchor point for cable management and equipment securing directly into composite hulls, fiberglass, or bonded structures during construction or retrofit.

Each mount is engineered to accept standard #5 wire ties and delivers an average pull strength of 150 pounds—more than sufficient for holding nav cables, sensor lines, and electrical harnesses under dynamic load. The black nylon construction resists saltwater corrosion and UV degradation, while the design allows installation directly into wet resin during hull layup or bonding with marine-grade acrylic adhesives for retrofit work. These mounts are specifically approved for submerged bilge applications, meaning they won't degrade when exposed to water, fuel, or the harsh chemicals found in engine compartments and below-deck spaces.

Professional boat builders and serious anglers restoring or upgrading vessels benefit most from buying in bulk—100 units ensure you have enough mounts for complete electrical and mechanical system organization without compromise. Whether you're managing wiring for electronics, securing hose runs, bundling fuel or water lines, or organizing equipment in tight cabin spaces, these mounts provide a clean, professional finish that lasts. The quantity offered here supports full-boat projects, multiple vessels, or shop inventory, making it the economical choice for marine contractors and experienced DIY restorers who understand that proper cable management directly impacts both safety and resale value.