SKU: 83002812
UPC: 050806101104
MPN: 1A29S910
Aluma-Hyde II in Matte Dark Parkerizing Gray is a hard-curing epoxy firearm finish engineered for shooters who refinish their own builds. This 12 oz aerosol applies a solvent-resistant coating that bonds to aluminum, steel, alloy, and plastic surfaces without requiring primer on bare metal or anodized parts. The dark parkerizing gray shade matches classic military phosphate finishes, making it a practical choice for AR-pattern rifles, shotguns, and handgun frames. We stock this formula for customers who want a durable, professional-looking finish without the cost of professional Cerakote application.
The epoxy base contains high-density pigment that creates an abrasion-resistant, rustproof barrier on external firearm surfaces. Unlike standard spray paints, Aluma-Hyde II resists bore cleaners, solvents, and even trichloroethylene after full cure. Application requires surface temperatures between 70°F and 90°F, with the can held 12-15 inches from the work piece. The finish dries to light touch in 10-15 minutes and reaches full cure in 10-14 days at room temperature, though warm air circulation at 90°F can accelerate cure time to approximately 2 days. The hydrophobic coating adds water resistance, while UV stability prevents fading. An included clean-out nozzle prevents clogs between uses. Note that this coating is not rated for temperatures exceeding 250°F and should not be applied to internal friction surfaces.
This finish works well for restoring worn receivers, refinishing stocks and grips, or building a cohesive look across mismatched parts. Hunters refreshing a beat-up shotgun, builders completing an AR rifle project, or collectors preserving a shooter-grade milsurp all benefit from the parkerizing gray tone. For prep work and maintenance, browse our cleaning equipment selection to ensure proper surface preparation before application.
No primer is required when applying to bare metal or anodized surfaces. The epoxy formula bonds directly to aluminum, steel, alloy, and plastic. For best adhesion, degrease and lightly abrade the surface before spraying.
Full cure takes 10-14 days at room temperature. You can accelerate this to approximately 2 days by circulating warm air at 90°F around the coated parts. The finish is not solvent-proof until fully cured.
No. This coating is designed for external surfaces only. It will not resist friction wear on internal components like bolt carriers, trigger groups, or barrel interiors. Use it on receivers, frames, handguards, and external hardware.
The coating is not rated for temperatures exceeding 250°F, so it is not recommended for barrel application on high-volume shooting builds. It performs well on receivers, stocks, and other external parts that stay below that threshold.
This shade replicates the classic military phosphate finish found on M16s, 1911s, and other mil-spec firearms. It provides a non-reflective matte appearance consistent with traditional parkerized steel.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
