Pacer Round 4 Conductor Cable - 100' - 16/4 AWG - Black, Green, Red & White

The Pacer Round 4 Conductor Cable – 100' – 16/4 AWG in black, green, red, and white is purpose-built for marine electrical systems where reliability and proper gauge separation matter most. Whether you're wiring a new console, running auxiliary systems, or upgrading a tired old harness, this four-conductor setup eliminates the guesswork and reduces connection points that can fail on the water. Boaters and marine technicians depend on pre-assembled, color-coded cable to minimize corrosion risk and ensure every circuit stays isolated and protected.

Rated at 16 AWG per conductor, this cable delivers the amperage headroom needed for moderate-draw accessories—navigation lights, trim systems, live-well pumps, and auxiliary charging circuits—without voltage drop that starves your electronics. The four-color conductor layout (black, green, red, white) follows standard marine wiring conventions, so ground, positive, and signal runs stay organized and traceable. The 100-foot length accommodates everything from a center console to a cruiser, and the round jacket resists UV degradation and saltwater intrusion better than flat ribbon alternatives when properly sealed at terminations.

Best suited for retrofit projects, auxiliary system runs, and marine builds where code compliance and longevity matter, the Pacer Round 4 Conductor Cable works with crimped terminals, solder, or splice connectors rated for wet environments. Installation on fiberglass or aluminum hulls requires conduit or loom in high-traffic areas to prevent chafing; bundle runs away from engine heat and raw-water through-hulls. This cable is not recommended for high-amperage main engine circuits or thruster applications—those demand heavier gauges—but excels as the backbone of modern console systems and accessory networks.