Out of stock
SKU: CERHMRUGLC9SCHPNK
UPC: 680220904014
MPN: HMRUGLC9SCHPNK
The CERUS GEAR Ruger LC9 Schematic ProMat in charcoal gray and pink is a cleaning and maintenance mat built for owners of Ruger's Lightweight Compact 9mm. The Ruger LC9 pink mat prints a detailed schematic of the pistol across a 12" x 17" padded work surface, with part names laid out so you can track springs, pins, and the takedown sequence while the gun is apart. It's a solid choice for anyone who carries the single-stack LC9 and wants an organized bench setup for routine cleaning, whether you maintain one carry pistol or a small collection.
Construction is 1/8" (3mm) vulcanized rubber bonded to a soft heat-pressed polyester top. That gives the mat a non-slip base that grips the bench while protecting both the work surface and the pistol's finish. The full 12" x 17" work area lays out the LC9 schematic with labeled components, and the LC9 pink artwork is applied with dye sublimation printing, so it won't wear or rub off with handling. The polyester surface is solvent and oil resistant, which matters when you're running cleaners and lubricants near a labeled diagram. The mat rolls up for storage, is hand washable, and carries a lifetime warranty against manufacturer's defects. It pairs naturally with a pistol cleaning kit and a quality gun oil at the bench.
Spread the mat out before you start a takedown and the schematic doubles as a reference while you work, which keeps detail-strip parts where you can find them. The non-slip base catches dropped pins and rolling springs that would otherwise hit the floor. It works for routine field cleaning after range sessions and for deeper maintenance when you're inspecting the LC9's internals. If you're building out a bench, browse our cleaning mats and round out your setup with our pistol cleaning kits and lubricants.
The schematic is printed specifically for the Ruger LC9, so the diagram only matches that pistol. The 12" x 17" work surface is large enough to use as a general bench mat for other handguns, but the labeled parts diagram applies to the LC9 (Lightweight Compact 9mm) alone.
No. The artwork is applied with dye sublimation printing, so it's bonded into the polyester surface rather than sitting on top of it. The top layer is solvent and oil resistant, which lets you run cleaners and lubricants near the diagram without fading or rubbing the print away.
The mat is hand washable. Wipe it down with mild soap and water to clear solvent residue, oil, and powder fouling, then let it air dry. The vulcanized rubber base and bonded polyester top hold up to repeated cleaning over the life of the mat.
The padded work area measures 12" x 17", which gives you room to lay out the LC9 and its small parts during a takedown. The mat rolls up for compact storage and weighs roughly 1 lb, so it stows easily in a range bag or on a shelf.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
