Fused 2 OHM Air Bag Delete Resistor 2pcs.

The Fused 2 OHM Air Bag Delete Resistor 2pcs by NRG Innovation is an essential component for builders removing factory airbag systems from performance and modified vehicles. Whether you're gutting an interior for weight reduction, converting to a custom steering wheel without airbag compatibility, or simplifying wiring in a dedicated track car, this resistor pair prevents dashboard warning lights and diagnostic trouble codes from flagging the deletion. Designed for serious enthusiasts and fabricators, it allows clean airbag system removal without triggering check-engine lights or requiring expensive dealer scans.

Each fused 2-ohm resistor acts as an electrical load simulator, mimicking the airbag module's original impedance to keep the vehicle's body control module satisfied. The 2-ohm resistance value is calculated to match factory airbag circuit specifications, preventing open-loop detection that would illuminate warning indicators on the instrument cluster. By installing one resistor per airbag circuit location—typically driver and passenger sides—you maintain electrical continuity without the safety systems interfering with diagnostics. The fused design adds thermal protection, ensuring the resistor shuts down safely if excessive current flows through the circuit.

This two-piece set is ideal for street machines, motorsport builds, and dedicated track vehicles where airbag deployment is unnecessary or incompatible with custom interiors and harnesses. Installation requires basic electrical knowledge and soldering skills; connect each resistor inline with the factory harness connectors where the airbag modules were removed. Compatible with most vehicles using OBD-II diagnostic systems, though verification of your specific vehicle's airbag circuit resistance is recommended before purchase. Compact and lightweight at just 0.01 lbs, these resistors integrate seamlessly into any wiring harness without adding bulk or weight to your build.