Ball Joint Stud for 1210-103 GM

The Ball Joint Stud for 1210-103 GM is a precision-engineered replacement component designed for automotive enthusiasts and professional builders looking to fine-tune suspension geometry. Whether you are performing a routine rebuild or optimizing a performance setup, this stud provides the necessary clearance and articulation for demanding driving conditions. By utilizing an extended length design, it allows users to correct roll center and improve handling characteristics on specific General Motors platforms.

Constructed from high-strength steel, this ball joint stud features a durable black oxide finish to resist corrosion and wear over time. It is engineered with a 2.000 inch per foot taper and a 1.438-inch ball diameter to ensure a precise fit within compatible housing units. The 1/2-20 inch thread pitch provides secure fastening, while the 4.35-inch overall length includes a 0.5-inch extended section specifically intended to modify suspension height or geometry.

This component is specifically designed for use with QA1 1210-103 ball joint assemblies and various GM-based suspension systems requiring an extended stud. It serves as a critical upgrade for racers and custom car builders who need to accommodate lowered ride heights without sacrificing suspension travel or alignment integrity. Installation is straightforward for those familiar with suspension maintenance, ensuring your vehicle remains stable and responsive during high-performance maneuvers.