Bump Stop Red Molded 1in

The RE Suspension Bump Stop Red Molded 1in is a precision polyurethane isolation component engineered to manage shock compression and absorb impact energy in suspension systems. Built from 85A durometer polyurethane, this bump stop provides controlled cushioning that protects suspension components from bottoming out during extreme compression events—a critical function in both street and off-road applications where suspension travel can be fully utilized.

With a 2-inch outer diameter and 0.625-inch inner diameter bore, this molded bump stop integrates directly into RSW 3 Series shock mounts and skate-style suspension components. The 1-inch height specification allows precise tuning of compression travel, while the high-durometer polyurethane compound resists permanent set and maintains consistent progressive rate across repeated cycles. The red color simplifies identification during assembly and maintenance. This component weighs just 0.09 lbs, adding negligible unsprung mass while delivering reliable performance over thousands of compression cycles.

Bump stops are essential for serious suspension builders, off-road enthusiasts, and track-focused drivers who operate at the limits of suspension travel. Whether protecting a fully compressed coil-over setup during aggressive terrain, managing bottom-out events on a street-driven performance vehicle, or fine-tuning the final compression rate in a motorsports application, proper bump stop selection prevents expensive component damage and maintains predictable suspension behavior under load. RE Suspension's molded design ensures consistent geometry and performance compared to wrapped elastomer alternatives.

This part is sold individually, making it ideal for single-shock replacement or custom suspension geometry. Verify compatibility with your specific shock mount design before ordering, as this component is engineered for RE Suspension RSW 3 Series and compatible aftermarket suspension platforms.