Torsion Arm Midget Right Rear BLK 33.5in Set Back

The Torsion Arm Midget Right Rear BLK 33.5in Set Back from MPD Racing is a precision rear suspension component engineered for open-wheel and midget racing vehicles. This passenger-side (right rear) torsion arm delivers the geometry and stiffness necessary for consistent cornering performance and predictable weight transfer during competitive racing. Whether you're tuning a midget for dirt oval or asphalt circuits, a properly matched torsion arm system is essential to translate driver input into responsive handling.

Manufactured from high-strength aluminum and finished in black anodized coating, this torsion arm resists corrosion and wear while maintaining minimal unsprung weight—critical for midget racing where suspension compliance and responsiveness directly affect lap times. The 33.5-inch setback dimension is a key geometry spec that defines the arm's length and mounting angle relative to the chassis centerline; this setback value allows tuners to dial in ride height, anti-roll characteristics, and load distribution. The arm ships hardware-included, simplifying installation and ensuring compatibility with standard mounting points on MPD Racing midget platforms and similar spec racing frames.

Serious midget competitors and chassis builders rely on matched sets of front and rear torsion arms to achieve balanced suspension geometry and predictable on-track behavior. This right rear unit pairs with a corresponding left rear arm to complete the rear suspension setup; because torsion arms experience lateral and vertical loads under acceleration and cornering, OEM or purpose-built racing replacements like this one are essential wear items that should be inspected and replaced seasonally. Installation requires basic mechanical skill and access to a midget-specific or universal racing lift; alignment and preload settings should be verified against your chassis builder's or team engineer's baseline setup sheets for optimal results.