SKU: MOR60110
UPC: 084663601101
MPN: 60110
The MOROSO Timing Pointer is built for Small Block Chevy builders running a 6.750" outside-diameter harmonic balancer who need a clean, repeatable reference for ignition timing. It mounts close to the damper so the pointer sits right over the timing marks, making it easier to read advance under the bay light or on the dyno. If you're degreeing in a distributor, setting initial advance, or verifying a timing curve on a carbureted small block, this pointer gives you a fixed datum you can trust pull after pull. It pairs naturally with the rest of a small block valvetrain and ignition build.
Construction is billet aluminum with a black anodized finish, and the mounting hardware is stainless steel, so corrosion under hood heat and washdowns isn't a concern. The design hugs the balancer to keep the pointer tip close to the timing tape or stamped marks, which cuts down on parallax error when you're eyeballing degrees. MOROSO builds in up to 4 degrees of adjustment, letting you fine-tune the pointer's position to match your specific balancer and timing tape without slotting or modifying brackets. The 60110 is sized specifically for the 6.750" balancer, so the bracket geometry lines up where it should. Pair it with a fresh degree timing tape for a complete, accurate reference setup.
Reach for this pointer when you're rebuilding a small block, swapping in a new damper, or chasing a timing problem and want a reference you don't have to second-guess. Racers running multiple events appreciate that the adjustable design lets them re-zero quickly after a balancer change. It's a low-cost piece that pays off every time you pull a timing light. Builders working through a full bottom-end and rotating-assembly project will find it sits well alongside a matched crank pulley and the other timing components we carry for small block Chevy engines.
This pointer is sized specifically for Small Block Chevy engines running a 6.750" outside-diameter harmonic balancer. The bracket geometry positions the pointer tip over the timing marks on that balancer size, so confirm your damper measures 6.750" OD before ordering.
MOROSO builds in up to 4 degrees of adjustment. That lets you fine-tune the pointer's position to align with your timing tape or stamped marks after a balancer swap, without slotting brackets or modifying the mount.
It's machined from billet aluminum with a black anodized finish and ships with stainless steel mounting hardware. That combination holds up to underhood heat and washdowns without corroding.
If your balancer already has accurate stamped degree marks, the pointer works on its own. For balancers without clear marks, or when you want finer resolution, pairing it with a degree timing tape gives you a precise reference across the full advance range.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
