Steering Column Bracket 10in

The ALLSTAR PERFORMANCE Steering Column Bracket 10in is a weld-on steel support bracket engineered for custom steering column installations in racing, hot rod, and restoration projects. This 10-inch steel bracket provides rigid column positioning and alignment in fabrication work where factory mounting points are absent or incompatible with custom frames and chassis designs.

Measuring 10 inches in length with compact cross-section dimensions of 3.3 x 2.15 inches, the bracket is sized for direct welding integration into frame structures. The natural steel finish allows painters and fabricators to apply their choice of primer, paint, or protective coating without factory finish interference. At 1.35 lbs, the bracket adds minimal mass while maintaining the structural integrity required for steering column support under acceleration, cornering, and road vibration typical of competition and custom vehicle environments.

This bracket is intended for experienced fabricators and chassis builders who handle steering column welding and alignment as part of full-frame restorations, street rods, race car builds, and custom off-road vehicles. The weld-on design requires proper welding equipment and skill to ensure safe column support. Buyers should verify that bracket geometry and mounting angle suit their specific column diameter and frame rail configuration before welding.

ALLSTAR PERFORMANCE is recognized as a supplier of chassis and frame components for racing and restoration applications. This steering column bracket represents the type of foundational hardware that allows custom builders to engineer non-standard steering installations where production mounting is not available. Proper welding, alignment, and testing are essential to steering safety in any vehicle application.