Linkage Kit Tri-Power # 39610

The Linkage Kit Tri-Power #39610 by FiTECH FUEL INJECTION is a universal throttle linkage solution engineered for carbureted-to-EFI conversion builds and custom fuel injection retrofits. Designed specifically for the Go EFI Tri-Power fuel injection system, this kit addresses one of the most critical challenges in modern engine swaps: mechanical throttle signal integrity from pedal to injector body. Whether you're converting a classic muscle car to sequential fuel injection, upgrading a street rod, or fine-tuning a performance engine bay, proper linkage geometry is non-negotiable for drivability and throttle response consistency.

This kit employs precision stud and rod end connections that allow adjustable, repeatable throttle cable routing from your pedal assembly to the fuel injection throttle body. The universal design accommodates various engine bay layouts and cable angles without binding or dead spots, critical factors that prevent stumbling, hesitation, or full-throttle cut-outs during acceleration. At 0.79 lbs with compact 5.1 x 4.7 x 20.4-inch packaging, the assembly integrates cleanly into tight engine compartments while maintaining the mechanical advantage needed for consistent EFI operation. The rod ends and studs are manufactured to tight tolerances, eliminating slack that would otherwise introduce lag between driver input and fuel injection response.

Mechanics and tuners installing FiTECH Go EFI systems—particularly Tri-Power setups on LS, small-block Chevy, Ford, and Mopar platforms—depend on this kit to achieve bulletproof throttle control without custom fabrication. Installation is straightforward: secure the linkage kit between your existing throttle cable and the Go EFI Tri-Power throttle body, then adjust rod ends for optimal cable geometry. This universal approach eliminates guesswork and ensures your fuel injection system responds instantly and predictably, whether cruising boulevard shows or launching at the strip. Compatible with any engine running Go EFI Tri-Power fuel injection, the Linkage Kit Tri-Power #39610 is essential for any serious carb-to-EFI conversion or performance engine modification project.