Out of stock
SKU: CW54759
UPC: 776113305003
MPN: 3050-F
The Dock Edge Wake Watchers Mooring System is a spring-tensioned dock protection setup built for boat owners who want their vessel held steady without constant fender babysitting. It moors boats up to 3500 lbs (1500 kg) and automatically repositions the hull roughly 3 ft (1 m) off the dock once passengers are aboard or off. That means easy boarding when you need the boat pulled in close, and reliable standoff distance the rest of the time. It suits private docks, lifts, and slips where wake and wind keep pushing a boat into the dock face. Owners shopping our anchoring and docking lineup use it as a hands-off alternative to manual line tending.
Each arm assembly mounts to the dock and uses adjustable tension to absorb lateral, vertical, and horizontal motion, so the boat is held off rather than slammed against pilings or the dock edge. Wake watchers installation depends on arm spacing: per the manufacturer's assembly instructions, you measure the distance between your boat's cleats and add 18 inches to set the gap between arms, then angle the arms in toward each other by about 15 degrees. Adjustable tension lets you dial in resistance for your boat's weight and your local water conditions. The 3500 lb (1500 kg) capacity covers a wide range of runabouts, pontoons, and small cruisers. The system earned coverage in Popular Science for its automatic standoff design.
This is the setup for an owner who's tired of fenders sliding out of place or lines that need adjusting every time the tide or wake shifts. Pull the boat in to load gear and passengers, then let the arms push it back to a safe 3 ft standoff when you step off. It pairs well with proper dock cleats and a set of fenders for added contact protection during heavy weather. If your dock takes a beating from passing wakes, browse our full mooring whips and standoff options to compare hold methods.
Per the Dock Edge assembly instructions, measure the distance between your boat's cleats and add 18 inches to determine the gap between the arm assemblies. The arms should angle in toward each other by approximately 15 degrees so the system pulls the boat to the correct standoff position.
The system is rated to moor boats up to 3500 lbs (1500 kg). That range covers many runabouts, pontoons, and small cruisers. Match the capacity to your boat's loaded weight, not just the dry hull weight, to keep the arms working within spec.
Once you board or step off, the spring-tensioned arms automatically reposition the boat about 3 ft (1 m) away from the dock. You can pull the boat in close for loading passengers and gear, then let it return to the safe standoff distance on its own.
It reduces the need for constant fender adjustment by holding the boat off the dock face and resisting lateral, vertical, and horizontal motion. Many owners still run fenders as backup protection during storms or heavy wake events for an added contact buffer.
Yes. The arms use adjustable tension so you can set resistance to suit your boat's weight and your local water conditions. Heavier boats and choppier water generally call for more tension to keep the standoff consistent.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
