SKU: JLA0100333800
UPC: 699440986489
MPN: 010-03338-00
The JL Audio MVi 6 channel marine amplifier (MPN 010-03338-00) is built for boaters who want clean, high-output sound that survives salt, spray, and vibration. It puts out 600 watts total RMS across six full-range channels, rated at 100W x 6 into 2 ohms or 75W x 6 into 4 ohms at 14.4V. With an integrated full-featured digital signal processor on board, it handles crossovers, time alignment, and EQ without external hardware. This is a strong backbone for multi-zone systems on center consoles, pontoons, and cruisers where running several pairs of marine speakers off a single amp keeps the install clean.
Power comes from NexD2 Class D switching technology with DirectFET outputs, a design that runs efficiently and stays 2-ohm stable across all channels. Any two channels bridge to 4 ohms for 200W x 3, giving you flexibility to drive tower speakers or a subwoofer alongside cabin audio. The 24-bit/48kHz AKM AK7738 triple-core processor provides a 10-band parametric EQ, crossovers, time alignment, and routing, all tuned through JL Audio TuN software on a PC, tablet, or phone rather than physical knobs. The cast alloy chassis carries a marine-grade powder coat finish with corrosion-resistant hardware and connectors, and the stackable design saves space in tight bilge or helm installs. The power connector accepts 4 AWG copper wire, and three 10-inch speaker output harnesses ship in the box.
Anglers, wakesurf crews, and cruisers running zoned audio will get the most out of this amp, especially when paired with a capable head unit and quality wiring. The IP-addressable design supports multi-amplifier systems, and an optional network hub and Bluetooth control module expand it further. Advanced Rollback Thermal protection keeps it running through hot days on the water. Match it with marine-rated wire and connectors and a compatible source unit from our marine stereos lineup for a system that holds up season after season. Backed by a two-year limited warranty from JL Audio.
It delivers 600 watts total RMS across six full-range channels, rated at 100W x 6 into 2 ohms or 75W x 6 into 4 ohms at 14.4V. Any two channels can be bridged to 4 ohms for 200W x 3, so you can mix full-range speakers with a subwoofer or tower pair on a single amp.
Tuning is handled through JL Audio TuN software on a PC, tablet, or smartphone. The 24-bit/48kHz AKM AK7738 processor gives you a 10-band parametric EQ, crossovers, time alignment, and routing. There are no physical knobs or switches on the unit, which keeps the sealed chassis protected from moisture.
Yes. It uses a cast alloy chassis with a marine-grade powder coat finish, corrosion-resistant hardware, and sealed connectors. Advanced Rollback Thermal protection guards against overheating during hot days on the water, and the stackable design fits tight helm and bilge installs.
It is well suited to multi-zone systems thanks to six full-range channels and onboard signal processing. The IP-addressable design supports multi-amplifier setups, and optional network and Bluetooth control modules let you expand the system as your build grows.
The supplied power connector accepts 4 AWG copper wire. The amp also ships with three 10-inch speaker output harnesses, RCA terminal covers, Allen wrenches, and a connection guide to get the install started.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
