NavPod RMX4900 Uncut (Usable Face = 12.4"W x 7.4"H) (31.5cm W x 18.8cm H)

The NavPod RMX4900 Uncut is a rail-mount pedestal pod designed to secure autopilot controls, sailing instruments, or compact chartplotters directly onto existing stainless steel pedestal guards. With a usable face of 12.4 inches wide by 7.4 inches high (31.5cm × 18.8cm), this uncut NavPod mounts securely onto 1-inch or 1.25-inch diameter tubes using a nickel chrome-plated stainless steel arm. The 180-degree rotating design positions your instruments for optimal visibility from the helm, even when operating under a dodger during rough weather or extended offshore passages.

This NavPod configuration accommodates a wide range of marine electronics, from conventional autopilot heads to modern multifunction displays. The uncut format allows customization during installation—users can size the mounting face precisely to fit their specific instrument dimensions. Stainless steel construction resists salt spray corrosion, critical for vessels operating in coastal and offshore environments where galvanic degradation compromises standard metals. All internal wiring routes through the center of the pedestal support arm, keeping the deck clean and reducing trip hazards or snagging points common with surface-mounted cable runs.

Cruising sailors and offshore anglers value the RMX4900 for its robust mounting solution and flexibility. Whether you're installing a below-deck autopilot remote on a blue-water cruiser or positioning a compact GPS/plotter on a fishing vessel's hardtop, the pedestal-mount design keeps instrumentation at eye level without compromising deck space. The 180-degree swivel eliminates repositioning during shifts in sun angle or weather conditions, while the stainless arm absorbs vibration and load-induced flex that would stress bolt-on mounts or adhesive-based systems. At 8.8 pounds, the NavPod RMX4900 distributes weight low and centrally, avoiding the balance issues that plague higher-mounted electronics pods on smaller vessels.