Turning Point Hub Kit #707

The Turning Point Hub Kit #707 is a marine propeller hub assembly designed to isolate the propeller from direct engine and drive shock, extending the service life of your powerhead and transmission. Built for boaters who demand reliability without constant maintenance, this hub kit absorbs the rotational stress that occurs during acceleration, deceleration, and load changes. Whether you're running a high-performance outboard or an inboard setup, this hub system protects critical drivetrain components from premature wear and catastrophic failure.

The Turning Point Hub Kit #707 features inner splines that adapt to your specific engine's output shaft, ensuring a precision fit that prevents slip and wobble. The outer hub accepts a range of compatible propeller models, allowing flexibility in prop selection without replacing the entire hub assembly. This dual-interface design significantly reduces gear shock—the violent torque transfer that damages bearings, seals, and gearboxes. The lifetime warranty backing this kit reflects Turning Point's confidence in its engineering; you'll never need to purchase another hub kit system again if properly maintained.

Mechanics and serious boaters benefit most from this hub kit when upgrading to higher-horsepower engines or running in demanding saltwater or shallow-water conditions where shock loads spike dramatically. Installation is straightforward—the kit arrives ready to mate with standard outboard and inboard shafts. You'll save up to 30% in long-term drivetrain repair costs by eliminating the repeated damage cycles that would otherwise require gearbox overhauls. Weighing just 2.25 lbs and compact in design, the Turning Point Hub Kit #707 integrates seamlessly into any marine propulsion system seeking maximum durability and cost efficiency.