Inner Bearing For Six Pin Front Hub Sold Each

The Inner Bearing for Six Pin Front Hub from MPD RACING is a critical component for serious drag racers and high-performance vehicle builders who demand precision in their front-end geometry and load distribution. This bearing is engineered specifically for six-pin hub assemblies, which are commonly found in dedicated race cars and heavily modified street vehicles running independent front suspension setups. When you're pushing power through a custom front end, the integrity of your hub bearings directly impacts steering response, tire wear consistency, and overall handling predictability during hard acceleration and cornering.

Designed as an inner race component, this bearing sits within the six-pin hub assembly and manages radial and axial loads transmitted through the wheel and suspension to the frame. MPD RACING's precision manufacturing ensures tight tolerances and consistent fit, which eliminates play that could cause premature wear of adjacent components or introduce unwanted deflection during acceleration events. The bearing's compact dimensions—measuring 4.05 x 1.55 x 4.55 inches and weighing just 0.76 lbs—make it lightweight enough for race applications while maintaining the structural integrity required for sustained high-load cycling. Proper installation requires careful attention to preload and cleanliness, as contamination or misalignment can significantly reduce service life.

This inner bearing is ideal for bracket racers, head-gasket competitors, and street performance builders upgrading to or maintaining six-pin front hub configurations on cars with independent front suspension. Installation should be performed by experienced mechanics familiar with hub assembly procedures, as proper bearing preload and alignment are essential to avoid binding or excessive runout. Always replace bearings in pairs and use fresh, high-quality bearing grease rated for your specific application and ambient temperatures. Compatibility verification with your exact hub assembly and suspension design is recommended before purchase.