Out of stock
SKU: CW74522
UPC: 8051566301171
MPN: RA115
The Glomex Marine Antennas RA115 is a 4-way ratchet mount built for deck or bulkhead installation on boats that carry marine antennas. It accepts the standard 1-inch x 14 thread, so it pairs with most fixed-mount whip antennas, and its locking handle lets you adjust the antenna angle and snap it firmly in place. The four-position design gives boaters a way to lay an antenna down for low bridges or trailering and bring it back to vertical without tools. This mount suits anglers and cruisers who need a dependable base in a saltwater environment. Browse our full range of antenna mounts and accessories to match it to your setup.
Construction is UV-resistant reinforced nylon, which resists sun and salt without corroding the way some metal bases can. The base measures roughly 100mm high by 60mm wide, with an overall height of about 186mm including the handle, per manufacturer specifications. Two cable management features set it apart: a cable slot routes RG-8X or RG-58 coax cleanly through the base, and a built-in coax feed-through gives you a watertight seal where the cable passes into the deck. The four-position ratchet locks at each detent so wind and wake won't shift the antenna. In self-supporting mode it handles antennas up to 9 feet (2.7m), and Glomex backs the RA115 with a lifetime warranty.
Boaters reach for this mount when they want a single base that handles both adjustment and cable routing in one part. The ratchet lets you drop a tall antenna flat to clear a low bridge or to fit a covered slip, then return it to vertical for full signal coverage. The feed-through keeps water out of the cable run, which matters on any deck that ships spray. Pair it with one of our marine antennas and a length of coax, and you have a complete masthead or rail setup. See the rest of our marine communication gear to round out the install.
It uses the standard 1-inch x 14 thread, which is the common fitting for most fixed-mount marine whip antennas. That means it pairs with a wide selection of antennas without an adapter as long as they share the same thread base.
The RA115 includes a cable slot that routes RG-8X or RG-58 coax through the base, plus a built-in coax feed-through designed to create a watertight seal where the cable enters the deck. This keeps spray and standing water out of the cable run below.
In self-supporting mode the RA115 handles antennas up to 9 feet (2.7m) in length, per manufacturer specifications. Taller antennas typically need additional support beyond what a single ratchet base provides.
Yes. The four-position ratchet with locking handle lets you adjust the antenna angle and lock it at each detent. That makes it easy to lay a tall antenna flat for low bridges, trailering, or covered slips, then return it to vertical.
It is built from UV-resistant reinforced nylon, which holds up to sun and salt exposure without the corrosion concerns of some metal bases. Glomex backs the mount with a lifetime warranty.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
Glomex Marine Antennas
Glomex Marine Antennas
Glomex Marine Antennas