Dana 60 Installation Kit

The MOTIVE GEAR Dana 60 Installation Kit (RA29RMK) is a comprehensive master bearing and seal assembly package designed for Dana 60 differential rebuilds and installations spanning 1950–2014 model years. This kit bundles all essential components needed for proper differential setup: precision-ground bearings, crush sleeve, gaskets, fasteners, seals, shims, and thread locker compound. Dana 60 axles remain the standard for heavy-duty trucks, off-road vehicles, and performance applications where load capacity and durability are non-negotiable.

The kit's component selection reflects Dana 60 engineering requirements. Bearings must be properly seated and preloaded through the crush sleeve to prevent noise, vibration, and accelerated wear during operation. Shims allow technicians to dial in correct ring-and-pinion backlash—typically 0.005 to 0.009 inches—which is critical to differential longevity and noise control. Quality gaskets and seals prevent oil leakage and contamination. Thread locker ensures fasteners remain secure under the cyclic loads typical of towing, acceleration, and rough terrain.

This master kit is intended for rebuilders, restoration shops, and experienced technicians performing a complete Dana 60 differential service or repair. The 1950–2014 compatibility window covers classic trucks, vintage hot rods, modern Dodge trucks, and Chevy duramax platforms equipped with Dana 60 rear axles. Proper installation requires a torque wrench, bearing press, and understanding of differential geometry; following OEM service procedures and specifications is essential to achieving correct preload and backlash settings.

MOTIVE GEAR is recognized in the differential rebuild and performance axle community for quality OEM-replacement and upgrade components. Using a purpose-built kit rather than sourcing individual components reduces the risk of missing hardware or incompatible parts, and consolidates the bill of materials for any Dana 60 differential overhaul project.