Ancor Bilge Pump Cable - 14/3 STOW-A Jacket - 3x2mm² - 100'

The Ancor Bilge Pump Cable – 14/3 STOW-A Jacket – 3x2mm² – 100' is the marine-grade electrical backbone every boater and angler needs for reliable bilge pump operation. Whether you're running a center console offshore, a cabin cruiser on inland waters, or a fishing platform that sees heavy use, a properly sized and installed bilge pump cable is non-negotiable for engine compartment protection. This 100-foot spool delivers the length and quality needed to route power from your battery bank to the pump without voltage drop, corrosion, or safety compromise—critical in an environment where saltwater spray and constant moisture are facts of life.

Built to UL1426 marine-grade standards, the Ancor cable features premium tinned copper stranding that resists corrosion and electrolysis far better than bare copper alternatives. The STOW-A jacket provides superior UV, oil, and abrasion resistance—essential protection when cables run through tight engine compartments, past sharp edges, and under the harsh sun exposure typical of deck and cabin installations. The 14/3 conductor configuration (three 14 AWG conductors) paired with the robust 3x2mm² cross-section ensures low resistance over extended runs, minimizing the voltage sag that can prevent pumps from operating at full capacity when you need them most.

Anglers, cruisers, and commercial operators rely on this cable for automatic bilge systems that run 24/7 during storms or extended mooring periods. The 100-foot length accommodates everything from single-engine runabouts to larger vessels where the battery bank sits far from the bilge sump location. Installation is straightforward with standard marine terminals and breaker boxes; follow your vessel's wiring diagrams and local marine electrical codes to ensure the cable integrates safely into your existing system. Proper sizing prevents nuisance breaker trips and guarantees your pump will activate instantly when water accumulation demands it.