Pacer Orange 14 AWG Primary Wire - 100'

The Pacer Orange 14 AWG Primary Wire – 100' is purpose-built for marine electrical systems where reliability and durability are non-negotiable. After years running boats in saltwater and freshwater environments, you know that standard automotive wire simply won't survive the corrosive conditions found on deck and below the waterline. This USA-manufactured marine wire meets and exceeds the most stringent marine specifications, making it the go-to choice for boat builders, electricians, and serious anglers upgrading their vessel's wiring harness, charging systems, and accessory circuits.

The 14 AWG gauge delivers optimal amperage capacity for secondary circuits—navigation lights, bilge pumps, trim tabs, and spotlights—while the tinned copper conductor resists oxidation and salt spray that corrodes standard bare copper. Orange insulation serves a practical purpose: visibility during installation and troubleshooting in tight engine compartments and console backs where you need to trace wiring quickly. The 100-foot spool length accommodates full boat runs with minimal splicing, reducing failure points and maintaining signal integrity across longer circuit paths. Marine-grade insulation withstands temperature swings, UV exposure, and moisture penetration far better than general-purpose primary wire.

This wire is essential for anyone retrofitting electronics, installing new battery banks, upgrading to LED lighting systems, or completing a full electrical restoration on an older hull. Compatibility spans freshwater center consoles, saltwater offshore rigs, trawlers, and pontoons—anywhere marine-duty wiring is required. Use it for engine gauges, accessory relays, trim motor circuits, and any 12V or 24V DC primary power distribution where harsh environmental resistance is critical. The 2.2-pound spool is compact enough to store aboard yet substantial enough to handle most single-vessel projects without additional order delays.