Pushrod - 7/16 .165 w/ .210 Radius 9.175 Long

The Pushrod - 7/16 .165 w/ .210 Radius 9.175 Long by Trend Performance Products is a precision valve train component engineered for serious engine builders and mechanics seeking to optimize overhead valve (OHV) engine performance. Pushrods are the mechanical link between the camshaft and rocker arms, directly translating cam lobe lift into precise valve actuation. This specific configuration addresses high-performance applications where exact pushrod length, diameter, and radius specifications are critical to maintaining proper valve train geometry and minimizing deflection under load.

Manufactured by Trend Performance Products—a recognized leader in valve train technology—this pushrod features a 7/16-inch diameter with a .165-inch wall thickness, delivering the optimal balance of strength and weight for demanding engine builds. The .210-inch radius ball ends ensure proper seating on both the lifter and rocker arm, reducing friction and wear while maintaining consistent contact geometry throughout the valve cycle. At 9.175 inches in length, this pushrod is designed for specific engine blocks and cylinder head combinations where precise length is non-negotiable; even minimal variations can cause valve train geometry issues, improper valve lash, or catastrophic component failure under high RPM operation. The lightweight 0.3-pound design minimizes reciprocating mass, reducing inertia-related stress on rocker arms and fasteners during aggressive acceleration and sustained high-RPM running.

This pushrod suits engine builders, restoration specialists, and racers working on small-block Chevrolet, Ford, or other OHV platforms requiring exact valve train specifications. Before installation, verify your engine block, cylinder head, and rocker arm setup compatibility using manufacturer documentation or consultation with your engine builder. Proper pushrod length selection is absolutely critical—measure your specific combination or reference factory service data to ensure this 9.175-inch length matches your application. Installation requires care to avoid damaging the ball ends and should include thorough valve lash inspection and adjustment after assembly to confirm correct valve train operation.