Shock Bearing Kit - 1in (Pair)

The QA1 Shock Bearing Kit – 1in (Pair) is engineered for serious suspension builders and performance enthusiasts who demand precision articulation in their shock absorber assemblies. Whether you're upgrading a street-driven muscle car, prepping a competition vehicle, or building a custom suspension from the ground up, this spherical bearing pair eliminates bind and reduces friction at the shock mount interface. Purpose-built for COM-T series applications, these bearings allow smoother suspension geometry compliance and more consistent damping response under dynamic cornering and braking loads.

Each shock bearing kit contains a matched pair with 0.500 inch inner diameter and 1.000 inch outer diameter, designed to handle radial and angular misalignment without creating flat spots or chatter. The PTFE-lined construction provides low-friction movement while resisting wear from shock shaft micro-cycling, and the steel construction ensures durability under repeated compression and extension cycles. Included snap rings secure the bearing assembly in place, simplifying installation and ensuring the bearing remains centered under load. The compact 1.000 inch thickness fits within tight shock tower and fabricated mounting brackets typical of custom suspension setups.

Buyers upgrading independent front suspension systems, double-wishbone platforms, and fabricated chassis benefit most from this kit when achieving consistent suspension travel and eliminating unwanted compliance at shock mounts. Installation requires basic chassis tools and accurate bore measurement to ensure proper fit. Use this bearing pair in custom shock mounting points where factory rubber isolators have been replaced with solid mounts, or where suspension geometry requires angled shock placement that induces side loads on the damper body. Always verify inner and outer diameter clearances before assembly to guarantee smooth operation and maximum bearing service life.