SKU: BEBAGSRSEXB6TXR
UPC: 855959003202
MPN: BAG-SRS-EXB6-TXR
The Bond Arms B6 Grip with Textured Back Strap is a replacement grip panel set built for the Standard Stinger RS, the steel-frame derringer in the Bond Arms lineup. These grips were developed by Bond Arms Inc. to give shooters a fuller, more controlled hold on a small two-shot pistol that produces sharp recoil for its size. The textured back strap and enhanced palm swell fill the hand instead of letting the pocket-pistol frame slip under recoil. If you carry a Stinger RS and want a grip that gives you more purchase without changing the gun's footprint, this set is built for exactly that.
Bond Arms makes the B6 panels from a high-strength, impact-resistant resin and ships them as a matched left and right pair. The standout feature is the texture itself, which Bond Arms calls an industry first for their grip line, paired with a palm swell that supports a full-handed grip rather than the two- or three-finger hold typical of derringers. That combination is aimed squarely at controlling powerful loads, where the steel-frame Stinger RS earns its reputation. Note the fitment: these grips are made for the steel-frame Standard Stinger RS and do not fit the original aluminum-frame Stinger. The MPN is BAG-SRS-EXB6-TXR. Installation uses the existing Bond Arms grip hardware, so you are swapping panels, not modifying the frame.
These grips suit anyone running a Stinger RS as a backup or deep-concealment piece who wants better recoil management from heavier defensive loads. The textured back strap matters most on the draw and during follow-up, when a smooth panel can shift in a sweaty or gloved hand. Swapping panels takes minutes and keeps the pistol's compact carry profile intact. For other handgun grip upgrades, browse our grip panel selection or the broader grips, pads, and stocks category, and check the matching Bond Arms extended grips if you want a different texture and material.
No. These B6 grips with textured back strap are made for the steel-frame Standard Stinger RS. Per Bond Arms, they do not fit the original aluminum-frame Stinger. Confirm your frame type before ordering, since the two frames use different grip geometry.
Bond Arms builds the B6 panels from a high-strength, impact-resistant resin. The material holds the textured surface and palm swell while standing up to the recoil and handling a steel-frame derringer sees in regular carry and range use.
Yes. The B6 set ships as a matched left and right grip panel pair, so you receive both sides needed to outfit one Standard Stinger RS. They install onto the existing Bond Arms grip hardware.
The textured back strap adds friction where your palm contacts the grip, which helps control follow-up shots with heavier defensive loads. Combined with the enhanced palm swell for a full-handed hold, it reduces slip compared to a smooth panel under recoil.
Yes. You are replacing the existing grip panels using the same Bond Arms grip hardware, not modifying the frame. The job takes only a few minutes and keeps the Stinger RS at its original compact carry footprint.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
