Harness Adapter Mini Del phi Multec 2 to EV6

The Harness Adapter Mini Delphi Multec 2 to EV6 from ICT BILLET is a precision fuel injector connector solution designed for engine builders, tuners, and mechanics performing fuel system upgrades or engine swaps. This adapter set bridges the gap between legacy Mini Delphi Multec 2 fuel injectors and modern USCAR EV6 harness configurations, eliminating the need for expensive injector replacement or custom wiring when integrating older injector hardware into contemporary engine management systems. Whether you're restoring a classic platform with modern EFI or adapting proven fuel delivery components to a new platform, this harness adapter provides a direct, plug-and-play electrical connection.

Each set includes eight adapters—one for each cylinder—manufactured from precision billet construction to ensure reliable, low-resistance electrical contact and long-term durability under underhood conditions. The Mini Delphi Multec 2 connector is the two-pin female design used on many late-1990s to early-2000s port-injected engines, while the USCAR EV6 (also called OBD-II) is the standardized male connector found on most modern fuel injectors and OEM harnesses. By maintaining factory-spec connector geometry and using quality materials, these adapters preserve signal integrity for proper injector pulse width modulation and fuel delivery accuracy, critical factors in tuning and engine performance. The compact 0.21 lb total weight and minimal footprint make installation straightforward in tight engine bay environments.

This adapter set is ideal for LS engine conversions, carbureted-to-fuel-injection retrofits, engine bay transplants, and any project where OEM or proven aftermarket fuel injectors from an older platform are being integrated into a modern vehicle or aftermarket ECU harness. Experienced technicians and DIY builders appreciate the flexibility and cost savings these adapters provide—allowing reuse of quality injector hardware rather than purchasing all-new components. Installation requires no special tools; simply connect the Mini Delphi Multec 2 injector connector to the female side and the EV6 harness to the male side. Verify polarity before assembly and test injector pulse and fuel pressure after startup to confirm proper operation.