SKU: ALL 54100
UPC: 848238027426
MPN: ALL54100
The ALLSTAR PERFORMANCE Gas Pedal (ALL54100) is a universal throttle pedal assembly built for street rods, race cars, and custom builds where the factory pedal arrangement doesn't line up with your floor or firewall. It uses a straight foot box mount design, which makes it a straightforward swap for builders fitting a new chassis or relocating throttle hardware. Allstar Performance sells this as a single piece, finished in black powder coat over steel. For shops working through a full interior and accessories overhaul, it's a clean, no-frills throttle pedal that mounts flat and runs a standard cable.
Construction is tubular steel with a black powder coat that holds up to repeated foot contact and the heat of a working engine bay. The straight foot box mount sits flat against the floor of the foot box, giving a consistent pivot point for cable-actuated throttle setups. This is a universal pedal, so it isn't pre-drilled for a single make or model; you set the mounting holes and cable routing to match your build. Allstar lists the pedal length at 1 inch at the mount reference. The black powder coat finish resists scuffing better than bare or painted steel, which matters on a part that takes constant wear. Builders pairing this with a matching clutch setup often look at a dedicated clutch pedal for the same foot box.
This pedal suits hot rod, restomod, and circle-track builds running a mechanical throttle cable rather than drive-by-wire. If your foot box is custom-fabricated or you've moved the engine and the stock pedal no longer reaches, the universal mount lets you set geometry where you need it. It works alongside a dead pedal for the left foot and pairs with the rest of the pedals and pedal pads in a clean build. Buy it as a single unit and add a brake or clutch assembly to complete the foot box.
It's a universal pedal assembly, not a direct-fit part for a specific make or model. You set the mounting holes and cable routing to match your foot box. That makes it well suited to custom chassis, street rods, and race builds where the factory pedal geometry no longer works.
The pedal is tubular steel with a black powder coat finish per manufacturer specifications. The powder coat resists scuffing and wear better than bare or painted steel, which matters on a part that takes constant foot contact and engine bay heat.
No. This is a mechanical throttle pedal built for cable-actuated setups. If your vehicle uses an electronic drive-by-wire throttle, you'd want a sensor-equipped pedal instead of this cable-style assembly.
It's sold as a single pedal (Each). To complete a foot box you'd add a separate brake assembly and, if you're running a manual transmission, a clutch pedal as well.
The manufacturer part number is ALL54100, SKU ALL 54100, UPC 848238027426. Reference these when ordering or matching it to other Allstar Performance foot box components.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
