SKU: CW85295
MPN: SN0036A
The Faria Beede Instruments 2" Thru-Hull Depth/Temp Transducer (SN0036A) gives boaters simultaneous depth and water temperature readings from a single integrated sensor. It's built for fishing boats, center consoles, and cruisers that run a Faria depth sounder display and need accurate readings of what's happening under the hull. The transducer mounts directly through the boat's hull and operates at 235 kHz, with the temperature probe housed in the same unit so you're not running a separate sensor. For anglers tracking thermoclines or skippers watching shoaling water, this is a straightforward thru-hull option. Browse our full lineup of marine transducers for matching displays.
This transducer ships with a 26-foot cable terminated in a bare wire connection, giving you length to route from the hull penetration to a console-mounted display without splicing on an extension. The body uses marine-grade, saltwater resistant construction to hold up in the conditions it's installed for. The 235 kHz operating frequency drives both the depth sounding and the integrated temperature reading, and the temperature sensor sits inside the same unit rather than as a separate add-on. The 2-inch gauge diameter is sized for standard 2-inch marine instrument openings, so it pairs with Faria depth sounder displays already in that footprint. Built in the USA, the SN0036A is supplied as the transducer only, ready to wire into a compatible head unit.
If you're rigging a new build or replacing a failed sensor, this transducer fits boats running a Faria depth display in the standard 2-inch gauge size. It suits skippers who want depth and temperature off one through-hull penetration instead of drilling for two separate sensors, which matters on smaller hulls where space and fairing are limited. Plan the mounting location for clean water flow and route the 26-foot cable back to the helm before final wiring. Pair it with the right display from our marine gauges selection, and check our transducer accessories for fairing blocks and mounting hardware.
Yes. The SN0036A provides simultaneous depth and water temperature readings from a single unit. The temperature probe is housed inside the same transducer body, so you do not need a separate temperature sensor or a second hull penetration to get both readings.
The transducer comes with a 26-foot cable terminated in a bare wire connection. That length lets you route from the hull penetration to a console-mounted display on most boats without adding an extension or splicing the run.
It fits standard 2-inch marine instrument gauge openings and is compatible with Faria depth sounder displays. It is supplied as the transducer only, so you'll need a matching head unit to read depth and temperature.
This is a thru-hull transducer. It mounts directly through the boat's hull for a clean, in-water sensing position. Plan the mounting location for unobstructed water flow before drilling and routing the 26-foot cable to the helm.
The SN0036A operates at 235 kHz, which drives both the depth sounding and the integrated water temperature reading. It is built in the USA using marine-grade, saltwater resistant construction.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
Faria Beede Instruments
Faria Beede Instruments
