SKU: CW83070
MPN: A2C99793900
The Veratron Bus Termination Resistor for OceanLink® and AcquaLink® Gauges is an essential component for anyone running a modern marine network backbone on their vessel. This termination resistor ensures signal integrity across your integrated gauge network, preventing signal reflections and data corruption that can degrade instrument accuracy. Whether you're upgrading an existing system, troubleshooting intermittent gauge readings, or installing a new Veratron network from the keel up, this resistor is the invisible workhorse that keeps your critical onboard instrumentation communicating cleanly.
Bus termination resistors operate by matching the impedance of your gauge network's data line, absorbing signal reflections at the cable terminus and eliminating the electrical "noise" that can corrupt transmitted data. In marine environments where moisture, vibration, and electrical noise are constant threats to system reliability, proper termination is non-negotiable. Veratron's compact design (1 x 1 x 2 inches, weighing just 0.02 lbs) fits seamlessly into tight engine room and console spaces, while its engineered resistance value is precisely calibrated to work with OceanLink® and AcquaLink® network protocols. The minimal footprint and sealed construction ensure dependable performance in salt spray, temperature swings, and high-vibration applications typical of serious recreational and commercial vessels.
Install this termination resistor at the end of your OceanLink® or AcquaLink® network bus—typically near your outermost gauge or at the final node in your system architecture. Anglers and offshore cruisers who depend on real-time engine data, fuel consumption tracking, and navigation instrument synchronization benefit most from clean signal transmission, especially on longer backbone runs. If you're experiencing intermittent gauge dropout, erratic temperature or pressure readings, or slow network response times, a fresh termination resistor often resolves the issue without requiring expensive gauge replacement. Compatible with all Veratron OceanLink® and AcquaLink® equipped systems, installation is straightforward and requires no special tools or marine electrician certification.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
