SKU: CLTHG102
UPC: 709750015219
MPN: HG102
The Cole-TAC handguard wrap (HG102) is a slip-on cover that adds grip and insulation to a rifle handguard without adding rail hardware or permanent modification. This is the no-slots version in Coyote Brown, meaning it presents a solid wrap surface with no cutouts for accessory ports. Precision and field shooters use it to cut felt heat from a hot barrel during extended strings and to give the support hand a consistent purchase in wet or cold conditions. It's a simple piece of kit that solves two problems a bare handguard doesn't, and it installs in seconds. See our full lineup of range accessories for related gear.
The wrap measures 7.5 inches in length, sized to cover the working section of most standard handguards where the support hand rides. The no-slots design keeps the surface continuous, so there are no gaps to catch or pinch, and the fabric holds its shape once seated. The Coyote Brown finish pairs cleanly with earth-tone rifles and stocks. Unlike bolt-on rail panels, this wrap requires no tools and no rail real estate, which keeps weight down and leaves your handguard footprint unchanged. Cole-TAC builds its shooting gear in the United States, and the wrap carries MPN HG102 and UPC 709750015219. If you want an accessory-port version, the slotted variant covers the same footprint with cutouts.
This wrap earns its place on a precision rig, a duty carbine, or a hunting rifle where the support hand needs a repeatable grip and the barrel runs hot during longer sessions. Prone and barricade shooters get a softer, warmer surface to load against, while the added insulation matters most after a magazine or two through a lightweight profile. Pair it with a stable front rest and a rear bag, and check the slotted Cole-TAC wrap if your setup runs rail-mounted lights or sensors. Browse the rest of our shooting rests and range accessories to round out your bench and field kit.
The wrap measures 7.5 inches long per manufacturer specifications. That length covers the working portion of most standard rifle handguards where the support hand rides, so you get grip and heat insulation over the section that matters most during longer shooting strings.
The no-slots version (HG102) has a continuous surface with no cutouts for rail-mounted accessories. It's built for handguards where you don't need port access along the covered area. If you run lights, lasers, or sensors on the handguard, the slotted Cole-TAC version leaves those ports open.
No. This is a slip-on wrap that seats over the handguard by hand, with no tools and no rail hardware required. It adds negligible weight and leaves your handguard footprint unchanged, which is why shooters use it as a quick add-on rather than a permanent rail panel.
Two reasons: grip and heat. The wrap gives the support hand a consistent, warmer surface to load against in wet or cold conditions, and the added material cuts felt heat off a hot barrel during extended firing. It's most noticeable on lightweight barrel profiles that heat up quickly.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
