SKU: ENE9-11110
UPC: 703639730293
MPN: 9.11110
The Energy Suspension Formula 5 Prelube3 3-pack is the factory pre-lubrication compound made for installing polyurethane suspension bushings without the squeaks that plague dry installs. If you're fitting control arm bushings, sway bar mounts, or body mounts from a polyurethane kit, this is the grease the manufacturer specifies to go between the bushing and the metal shell or shaft. Each pack ships with three packets (MPN 9.11110), which covers a full suspension job with packets to spare. It's a straightforward consumable that earns its place in the toolbox right next to the rest of your oils, fluids, and sealers.
Formula 5 is a moly-fortified, water-resistant compound formulated to cling to polyurethane and resist washout, which is what stops the dry rubbing that causes bushing noise over time. It carries the heavy film strength you want at a high-load contact point between the bushing bore and the sleeve or bar, and it won't break down or migrate the way ordinary chassis grease can on poly. Each packet meters out a clean single-use dose, so there's no jar to contaminate and no guesswork on coverage. The 3-pack format gives you enough material for a complete corner-to-corner install, and the sealed packets store indefinitely until the next project. Pair it with a tube of moly paste for threaded fasteners and you've got the assembly bench covered.
Reach for the Formula 5 Prelube3 any time you're pressing in or sliding home polyurethane bushings, whether it's a full suspension refresh, a sway bar end link swap, or a transmission mount upgrade. Apply it to every bushing-to-metal contact surface during assembly to keep the joint quiet for the life of the part. Builders restoring a chassis or upgrading to poly across the board should keep a pack on hand before teardown. When you're stocking the bench for a rebuild, browse the rest of our grease and lubricants to round out the job.
It's a pre-lubrication compound applied to polyurethane suspension bushings during installation. You spread it on the contact surface between the bushing and the metal sleeve, shaft, or housing to prevent the dry rubbing that causes squeaks and premature wear once the suspension is loaded and moving.
Each pack contains three single-use packets, which is enough for a full corner-to-corner polyurethane suspension install on most vehicles with packets to spare. Coverage depends on bushing size and count, but a 3-pack handles a typical control arm, sway bar, and body mount job.
Properly applied, yes. Squeak comes from dry contact between the polyurethane and the metal it rides against. Formula 5 is water-resistant and clings to poly, so it stays in the joint and keeps the surfaces lubricated rather than washing out like ordinary chassis grease.
Standard petroleum chassis grease can degrade or migrate away from polyurethane over time, which leads to noise returning. Formula 5 is the compound the manufacturer specifies for poly bushings because it's formulated to stay put and resist washout at the bushing contact point.
The manufacturer part number is 9.11110, sold under our SKU ENE9-11110 with UPC 703639730293. It's the Energy Suspension Formula 5 Prelube3 in the 3-pack configuration.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
