Saunders Field Points 5/16 100 Gr. 100 Pk.

The Saunders Field Points 5/16 100 Gr. 100 Pk. represents a bulk purchasing solution for precision shooting applications where field points are essential for practice, tuning, and target work. Whether you're managing a range, outfitting an archery club, or stocking a personal arsenal for frequent shooting sessions, this 100-pack offers consistent, cost-effective projectiles. Field points are the foundation of any archer's toolkit—they're lighter than broadheads, safer for practice scenarios, and provide the trajectory data needed to dial in your setup before deploying hunting or competition equipment.

Each Saunders Field Points 5/16 100 Gr. projectile is engineered with a 5/16-inch shaft diameter and 100-grain weight, dimensions that balance kinetic energy, flight stability, and compatibility with standard arrow shafts. The 100-grain mass is a proven sweet spot for generating sufficient velocity while maintaining tight groupings at distance—critical when you're validating sight adjustments or paper-tuning your bow setup. Saunders delivers consistent manufacturing tolerances across the entire 100-pack, eliminating the frustration of mixed weights that can introduce vertical or horizontal spread. The field point design—typically featuring a simple conical or blunt tip—transfers energy efficiently to targets without the penetration complexity of broadheads, making them ideal for indoor ranges and outdoor 3D courses.

Archers preparing for season, competitive shooters refining technique, and range operators managing high-volume shooting benefit most from this bulk 100-pack format. The 5/16 shaft diameter ensures compatibility with most modern compound and recurve bows tuned for standard arrow spines, though compatibility always depends on your specific bow's draw weight and arrow spine selection. The 1.45-pound total weight of the 100-pack makes transport and storage practical, and the quantity supports sustained practice regimens without frequent reorders. Installation is straightforward—simply thread or glue these field points onto your prepared shafts using industry-standard techniques, then get downrange to validate your setup before making any equipment changes.