SKU: 749010234
UPC: 011516761538
MPN: 7726153
The Lyman T-mag Extra Turret is a spare six-station turret head for the Lyman T-Mag turret press, built for reloaders who run multiple calibers and want their dies set once and left alone. Instead of breaking down a single turret every time you switch cartridges, you keep a dedicated turret loaded for each setup and swap the whole head. That means your seating depth, crimp, and sizing adjustments stay locked exactly where you dialed them. For anyone loading several pistol and rifle rounds off one bench, a second turret is the fastest way to cut setup time.
Each turret accepts six standard 7/8"-14 threaded dies, giving you enough stations to hold a full three-die pistol set plus a powder-through die and crimp die, or a complete rifle die set with room to spare. The turret indexes on the T-Mag's retention system so dies return to the same position run after run, which matters when you're holding tight tolerances on a precision load. Built and machined to the same standard as the press it serves, this is a genuine Lyman part (MPN 7726153) rather than a generic substitute. Loaded turrets store flat, so a turret stacker keeps your extra heads organized and protected between sessions.
Reloaders who run the T-Mag for both handgun and rifle work get the most out of a second turret: dedicate one to 9mm and .45 ACP, another to .223 and .308, and switching becomes a thirty-second job. Pair extra turrets with the right shellholders and a stocked supply of rifle dies and you've got a bench that moves between cartridges without re-zeroing anything. If you load enough volume to justify pre-set turrets, this is the accessory that pays for itself in saved time. Browse our full reloading lineup to round out the setup.
This extra turret is made for the Lyman T-Mag turret press. It indexes on the T-Mag retention system and is a genuine Lyman part under MPN 7726153, not a generic aftermarket head.
The turret has six die stations, each threaded for standard 7/8"-14 dies. That's enough room for a full pistol set with a powder die and crimp die, or a complete rifle die set with stations to spare.
Keeping a separate turret for each cartridge lets you leave your dies set up permanently. Instead of readjusting seating depth and crimp every time you change calibers, you swap the whole loaded turret and keep your settings intact, cutting changeover to under a minute.
Yes. Any standard 7/8"-14 threaded reloading die fits the turret stations, regardless of brand. Set your dies, lock the rings, and the turret returns them to the same position run after run.
No. This is the turret head only. You supply your own dies and the correct shellholder for each cartridge you plan to load on it.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
