SKU: 100053632
UPC: 812308022413
MPN: 704G
This is a granulated black grip wrap (MPN 704G) cut specifically for the small backstrap of the S&W M&P Compact in 9mm. It's made for shooters who want more bite from the frame without sanding, stippling, or otherwise altering the polymer. The wrap conforms to the grip's contours and gives the support and firing hands a consistent texture under recoil. For anyone running an M&P Compact as a carry or range gun, it's a low-cost way to improve purchase on the frame while keeping the factory grip intact and reversible.
The granulated surface sits between sandpaper-grit aggression and a smooth rubber feel, so it adds traction without chewing up clothing on a concealed carry rig. It applies to the backstrap and side panels using the included adhesive backing, then trims flush to the frame lines. Because it's an applied wrap rather than a replacement panel, it adds effectively no bulk and won't change holster fit. The cut matches the M&P Compact geometry around the takedown points and magazine release, leaving controls clear. Install it clean and degreased, and the bond holds through repeated draws and live fire. If you want a coarser feel for a dedicated range pistol, the rubber and granulated textures each serve different jobs.
Buyers reach for this when their bare M&P Compact frame feels slick with sweaty hands or thin gloves, or when they want a repeatable grip index for faster follow-up shots. It works equally well on a duty gun, a nightstand pistol, or a competition setup. Pair it with fresh M&P magazines and run it hard on the range. While you're squaring away the gun, check our cleaning kits and handgun range bags to round out the kit. It's a simple upgrade that pays off every time you draw.
It's cut for the Smith & Wesson M&P Compact with the small backstrap installed, in 9mm. The wrap follows that frame's contours around the magazine release and takedown points, so it lays flat without overlapping controls. It will not fit full-size M&P or M&P 2.0 frames, which use different grip geometry.
The granulated finish is the middle texture in the lineup, more aggressive than smooth rubber but less abrasive than the coarsest grit options. It adds solid traction for the firing hand while staying friendly enough for concealed carry against a shirt. Holster fit is unaffected because the wrap adds effectively no bulk to the frame.
Clean and degrease the grip area first, then peel and press the wrap onto the backstrap and side panels, working out any air. Trim flush to the frame lines as needed. A clean, oil-free surface is the difference between a bond that holds through hundreds of draws and one that lifts at the edges.
Yes. The wrap is an applied adhesive layer, not a permanent modification, so it peels off when you want a change. Any adhesive residue cleans up with a solvent, leaving the factory polymer intact. That makes it a safer option than stippling for anyone who may sell or trade the pistol later.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
