Ball Joint Pin K6141 +.100in

The Ball Joint Pin K6141 +.100in from ALLSTAR PERFORMANCE is a precision replacement ball joint stud engineered for suspension systems where extended length geometry is critical to alignment and steering response. This component is essential for fabricators, suspension specialists, and high-performance builders who require factory-plus dimensions to accommodate custom chassis work, lowered ride heights, or modified A-arm configurations. Ball joint pins are load-bearing fasteners that connect the steering knuckle to the control arm, making material integrity and dimensional accuracy non-negotiable for safety and handling.

Manufactured from steel and finished in black oxide coating, this ball joint stud delivers corrosion resistance and durability under high-stress suspension loading. The +0.1 inch extended length specification allows tuners to fine-tune ride height geometry and maintain proper suspension angles when drop spindles or lowered control arms are installed. Black oxide provides a protective surface that resists rust while maintaining the clean appearance demanded in show and competition vehicles. The controlled dimensional tolerance ensures precise fit within existing ball joint sockets, eliminating play and maintaining accurate steering geometry throughout the suspension's range of motion.

This ball joint pin is ideal for street rod builders, circle track racers, and suspension engineers designing custom front-end geometry for performance applications. Installation requires pressing out the worn stud and pressing in the new pin using proper ball joint tools to avoid damage to the socket bore. Each pin is sold individually, allowing builders to replace both upper and lower joints as needed during a complete suspension refresh. Verify compatibility with your specific ball joint housing before ordering, as housing bore sizes and taper angles vary across suspension platforms.