Control Arm Screw-In Alum Shaft 7in 10Deg

The Control Arm Screw-In Aluminum Shaft 7in 10Deg is a precision suspension component engineered for custom automotive applications and performance vehicle builds. This adjustable control arm shaft addresses the specific needs of fabricators and tuners who require precise geometry correction, weight reduction, and improved suspension travel in modified chassis setups. Whether you're building a competition race car, lowered street machine, or custom hot rod, this screw-in design allows repeatable adjustments without permanent welding, making it ideal for prototype development and fine-tuning suspension geometry.

Constructed from lightweight aluminum, this 7-inch shaft delivers the strength-to-weight ratio necessary for performance applications while reducing unsprung mass that impacts acceleration, braking, and handling response. The 10-degree angle specification is critical for adjustable geometry setups, allowing you to dial in ride height, camber curves, and instantaneous center migration precisely as your suspension tuning demands. The screw-in design eliminates the need for cutting, welding, and re-machining control arms, saving fabrication time and cost while maintaining concentricity and thread integrity across repeated adjustments and disassembly cycles.

Suspension shops, custom fabricators, and serious DIY builds benefit most from this component when executing double-A-arm conversions, ground-up restorations, or advanced geometry packages on street, strip, and road course vehicles. The 7-inch length and 10-degree angle integrate seamlessly into modern independent suspension systems where precise ride height and camber control directly impact tire wear, cornering grip, and overall handling balance. Installation requires proper alignment equipment and suspension geometry knowledge; verify mounting dimensions against your specific control arm eyelet centers and desired suspension mounting points before ordering.