Out of stock
SKU: ENE4-7117R
UPC: 703639337683
MPN: 4.7117R
The Energy Suspension 4.7117R strut rod bushing kit delivers measurable improvements in steering response and suspension control for 1965-79 Ford vehicles. Factory rubber bushings deteriorate over decades, allowing the strut rod to deflect under load and introducing unwanted steering axis movement. This front bushing kit replaces those worn components with Hyper-Flex performance polyurethane, a material engineered to resist the compression set and degradation that plague original equipment rubber. Drivers restoring classic Mustangs, Falcons, Mavericks, and other Ford platforms will find these bushings restore the precise geometry their suspension was designed to maintain.
Energy Suspension manufactures these bushings from their proprietary Hyper-Flex polyurethane compound, which offers significantly higher durometer ratings than stock rubber while retaining enough compliance for street driving comfort. The material resists oil, grease, and road chemicals that accelerate rubber breakdown. Each kit includes all necessary components for a complete front strut rod bushing replacement. The red polyurethane construction provides visual confirmation of proper installation and serves as an indicator during future inspections. By controlling strut rod movement, these bushings reduce wheel hop during hard acceleration and minimize traction loss during aggressive cornering—conditions where soft factory bushings allow the suspension geometry to shift unpredictably. Browse our complete bushing selection for additional restoration components.
Classic Ford owners preparing their vehicles for spirited driving, autocross competition, or simply restoring factory-intended handling characteristics will benefit from this upgrade. The kit addresses a common failure point on vehicles with 45+ years of service, where original bushings have likely hardened, cracked, or compressed beyond acceptable tolerances. Installation requires basic hand tools and mechanical aptitude. Pair these strut rod bushings with fresh sway bar bushings and control arm components to complete a comprehensive front suspension refresh on your Ford restoration project.
This kit is designed for Ford vehicles manufactured between 1965 and 1979. Common applications include Mustangs, Falcons, Fairlanes, Mavericks, and other Ford platforms that utilize front strut rods. Always verify your specific vehicle application before ordering.
Factory rubber bushings degrade over time, causing steering wander, inconsistent alignment, and reduced traction. Hyper-Flex polyurethane resists compression set, oil contamination, and age-related deterioration far better than rubber, restoring precise suspension geometry and improving steering response.
Energy Suspension recommends using their formula 5 grease during installation to prevent squeaking and ensure proper function. The bushings install in the factory location using original hardware. Basic mechanical skills and standard hand tools are sufficient for most installations.
Polyurethane is firmer than worn rubber, so you may notice slightly increased feedback through the steering. However, Hyper-Flex compounds are engineered to balance performance gains with acceptable street comfort. Most drivers report improved road feel without objectionable harshness.
WARNING ⚠️ You must be 18 or older to purchase shotgun or rifle ammunition and 21 or older to purchase handgun ammunition and firearms. Please reference our requirements for ammunition orders to "restricted" states HERE. Always make sure you use the correct ammunition for your firearms. Ammo cannot be shipped to a PO Box. Please reference state & local laws before making a firearm or ammunition purchase.
