Ignition Panel Extreme 6 Switch Single Ignition

The Ignition Panel Extreme 6 Switch Single Ignition by QUICKCAR RACING PRODUCTS is purpose-built for high-performance marine and boating applications where reliable electrical control is non-negotiable. Whether you're running a custom center console, a performance boat, or a specialized marine craft, this ignition panel consolidates critical power distribution into one compact, accessible unit. Marine operators and boat builders rely on ignition panels like this to manage engine start circuits, accessory loads, and emergency shutoff functionality with the precision and redundancy demanded by life on the water.

The Extreme 6 Switch design features six independent switch positions, allowing simultaneous control of multiple circuits from a single mounting location—essential when space is premium and wiring complexity must be minimized. Each switch contact is rated for the amperage draws typical in marine starter circuits and accessory circuits, with toggle or rocker options depending on installation preference. The single ignition configuration means one master ignition source feeds the panel, reducing potential failure points and simplifying troubleshooting during pre-launch checks. Compact dimensions (5.4 x 5.2 x 5.5 inches) fit easily into dash pods, center console assemblies, or custom mounting brackets without sacrificing accessibility or ergonomic switch placement.

This ignition panel suits custom boat builders, marine electricians, and serious boating enthusiasts upgrading to modern electrical architecture. Installation requires basic marine-grade wiring practices and knowledge of your vessel's power budget; most operators will wire the master ignition feed directly to battery positive through a main fuse or breaker, then distribute switched circuits to starter solenoids, blower motors, bilge pumps, trim/tilt systems, and auxiliary loads. Weighing only 0.7 lbs, it adds negligible weight while dramatically improving cockpit organization and operational safety. Compatible with 12V and 24V marine electrical systems when properly fused, making it ideal for retrofit projects and new builds alike.