Torsion Bar Bushing .095 Sprint Car (4-Pack)

The Torsion Bar Bushing .095 Sprint Car 4-Pack (MPD30104) is engineered for serious sprint car racers and fabricators who demand precision suspension geometry. These bushings serve as critical isolation components between your torsion bars and frame mounts, absorbing vibration and maintaining consistent suspension articulation under extreme lateral and vertical loads. Whether you're campaigning a winged sprint car or a non-wing platform, quality torsion bar bushings are essential to transfer power efficiently while protecting your frame from accelerated wear and metal fatigue.

These MPD Racing bushings feature a .095-inch wall thickness, specifically designed to meet the rigorous demands of sprint car chassis tuning and suspension compliance. The four-pack quantity allows you to replace bushings on both front and rear torsion bar assemblies or maintain a spare set for race day emergencies. The compact dimensions (3.9 x 2 x 4 inches) and minimal weight (0.09 lbs per pack) make these bushings easy to transport and install, while the engineered elastomer composition balances vibration damping with resistance to fuel, oil, and extreme temperature cycling typical in high-RPM racing environments.

Sprint car racers, chassis shops, and suspension specialists rely on MPD Racing components for OEM-equivalent performance at competitive pricing. Installation is straightforward—remove worn bushings, clean the mounting surfaces, and press in the new .095 bushings using a hydraulic press or shop vice with proper tooling to avoid crushing. This 4-pack is ideal for single-car teams updating both ends of the torsion bar system or shops maintaining multiple sprint car platforms. Verify your specific torsion bar diameter and mounting configuration before ordering to ensure proper fitment on your particular chassis setup.